Wireless transmitter, Operating instructions, Handheld microphone – LightSpeed Technologies Delta X10 User Manual
Page 22
LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662
Operating Instructions
O
N
20
Wireless Transmitter
Handheld Microphone
Channel Selection – Handheld T
Channel Selection – Handheld T
Channel Selection – Handheld T
Channel Selection – Handheld T
Channel Selection – Handheld Transmitter
ransmitter
ransmitter
ransmitter
ransmitter
Once a channel has been selected on the receiver, you now need to select that same channel on the handheld transmitter.
If you
have a belt-pack transmitter, go to
page 23
for channel selection instructions.
ON
LCD
Display
LOCK
SET
HM-900
SET
LOCK
UP
DOWN
Red
LED
ON/OFF
Switch
CH: 002
CH: 002
720.500M
LS
HM-900
SENS SET
LEVEL [2]
NiMH
AKLN
Setup Screens
selectable with
the UP and DOWN
Arrow Buttons
•Turn the microphone on by sliding
the switch on the barrel to the ON
position. The red LED will flash once.
•Use the “up” and “down” buttons to
select a screen that shows the current
channel.
•To change the channel, press and hold
the “SET” button on the bottom of the
microphone until there is a blinking
cursor on the LCD display
window
(approximately 3 seconds).
•Use the “UP” and “DOWN” buttons to
set the channel to match the receiver.
•Press and hold the “SET” button again
until the blinking cursor disappears
and the red LED flashes
(approximately 3 seconds).
T
TT
TTransmission Frequency in MHz:
ransmission Frequency in MHz:
ransmission Frequency in MHz:
ransmission Frequency in MHz:
ransmission Frequency in MHz: Press the “UP”
button once to view the transmission frequency in
MHz of the currently selected channel.
NOTE: Transmitters and receivers
are available in 5 different frequency
groups. Verify that the letter code that
blinks on the receiver (when powered
ON) matches the letter code on the
frequency sticker in the battery
compartment of the transmitter.
CH: 002
720.500M
Lock Function
Lock Function
Lock Function
Lock Function
Lock Function
This allows users to lock out all the controls on the microphone so that it is not accidentally switched off or the channels aren’t
accidentally changed in the middle of a performance.
To lock all the controls:
•Press the “LOCK” button on the bottom of the microphone. A lock icon
will appear on the LCD screen next to the channel number.
•The black
(or colored) disc on the bottom can be rotated around to completely cover the controls so that the buttons
cannot be accidentally pressed again.
To unlock all the controls:
•Rotate the black
(or colored) disc back around to reveal the buttons on the bottom of the microphone.
•Press the “LOCK” button again to unlock. The lock icon will disappear.
LOCK
SET
HM-900
Rotate Disc to Secure
Controls
Ligh
tSPE
ED
CH: 002