Wireless transmitter, Operating instructions, Belt-pack – LightSpeed Technologies Delta X10 User Manual
Page 26
LightSPEED
GT
MT
Alkaline
NiMH
Nickel Metal Hydride
Rechargable
4
CH: 001
3
CH: 001
720.250M
1
2
Gain Adjust
GT
MT
LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662
24
Wireless Transmitter
Belt-pack
1.
1.
1.
1.
1. TTTTTransmitter Mute:
ransmitter Mute:
ransmitter Mute:
ransmitter Mute:
ransmitter Mute: The MUTE switch turns the transmitter’s audio signal on or off. The audio is off when the red LED is
flashing.
2.
2.
2.
2.
2. Gain Adjust:
Gain Adjust:
Gain Adjust:
Gain Adjust:
Gain Adjust: When changing microphones or users, it may be necessary to adjust the transmitter gain based on differing
microphone sensitivities and voice levels.
•To adjust the microphone gain, turn the MT dial clockwise to increase the gain and counterclockwise to decrease the gain.
•If you are using a high impedence source, such as a guitar, it will be necessary to adjust the GT dial. Using a high
impedance source requires a special cable.
Contact LightSPEED Technologies for more information.
3.
3.
3.
3.
3. Batter
Batter
Batter
Batter
Battery Life Indicator:
y Life Indicator:
y Life Indicator:
y Life Indicator:
y Life Indicator: The battery life is shown on the primary screen of the LCD. The 7-step fuel gauge acts as a
detailed guide to show the actual life of the battery.
4.
4.
4.
4.
4. Batter
Batter
Batter
Batter
Battery T
y T
y T
y T
y Type:
ype:
ype:
ype:
ype: The transmitter will operate with either standard Alkaline Batteries or Nickel Metal Hydride (NiMH)
Rechargable Batteries. Since these types of batteries have different characteristics, it is important to set the transmitter to
the appropriate type of battery being used so that the battery life indicator will operate properly.
Operating Instructions
LightSPE
ED
Battery
Compartment
Door
Latch
GT
MT
DOWN
Button
UP
Button
Set
Button
NiMH
AKLN
5
6
5.
5.
5.
5.
5. TTTTTo Change the Batter
o Change the Batter
o Change the Batter
o Change the Batter
o Change the Battery T
y T
y T
y T
y Type Setting:
ype Setting:
ype Setting:
ype Setting:
ype Setting:
•Press the “UP” button twice to get to the battery type screen.
•Press and hold the “SET” button until a blinking cursor appears.
•Use the UP and DOWN buttons to make a selection.
•Press and hold the “SET” button again until the blinking
cursor disappears.
6.
6.
6.
6.
6. Replacing the Batteries:
Replacing the Batteries:
Replacing the Batteries:
Replacing the Batteries:
Replacing the Batteries:
•Open the plastic door by depressing the latches on each side.
•Insert two AA batteries and snap the door closed.
Note the polarity in the battery compartment.
Typical battery life is about 8 hours.
NOTE: Do not mix battery types.
WARNING: Do not use NiCad
batteries! They will not charge
properly and may cause damage
to the transmitter.