Lenoxx Electronics CD-208 - Manual (Page 13)

IB-CD208(LC)-WM-E-060403
MP3 PROGRAMMED PLAY
During programming, the word PROGRAM shows in the display. To program play in
your preferred order, follow steps below:
1. Slide the FUNCTION switch to the MP3/CD position.
Make sure the set is in STOP mode.
5. Repeat above steps 3 and 4 to program other
tracks till you finish.
4. Press the PROGRAM button to confirm, the programmed
number will show in the display, and ready for the next
selection of track.
The tracks (songs) on the disc can be programmed (arranged in advance) to
play in any order you prefer (up to 20 tracks can be programmed).
NOTE:
1. Programming can only be done in STOP mode.
2. The programmed memory will be lost if the STOP button is pressed twice,
or the alkaline batteries are exhausted or removed, or AC power is shut off,
or the CD DOOR is opened.
3. The player will stop automatically after all programmed tracks have been
played.
6. After programming is finished, press the PLAY button
to begin programmed play.
2. Press the PROGRAM button once, the album number
“ ” will flash in the display.
3. Press the SKIP/SEARCH buttons ( or ) to
select album number, then press the PROGRAM button,
the letters “ ” will flash. Press the SKIP/SEARCH
buttons to select the track number to be programmed.
To cancel programmed play
Press the STOP button twice, the word PROGRAM will vanish from the display.
To change the current program
Just create a new program following the programming procedure.
12
album number
track number
programmed
number
Programming Example
Program Number 1 2 3 4 5 6 7 8
etc.
etc.
etc. Track Number (song number) 3 5 8 1 2 4 1 1
Album Number (title number) 3 6 10 4 1 7 2 5