Lenoxx Electronics CD-208 - Manual (Page 5)

IB-CD208(LC)-WM-E-060403
You can use the AC power or batteries as a power source.
4
To a wall outlet
• Replace all the batteries
with new ones when the
POWER lamp dims or
the player stops
operating. Before you
replace all the batteries,
be sure to take out the
disc from the player and
remember to check the
Battery Safety Instructions
on Page 3.
•
If the discs do not play
on batteries, this means
the batteries are almost
used up. But the radio
may continue to play on
these weak batteries
because it uses less
power than the disc
player.
TIP: 1. Connecting the AC power
Insert one end of the supplied AC power cord into
the socket located at the rear of the set, and the
other end into the 120V standard household outlet.
2. Using the player on batteries
Remove the AC plug from the back of the set and
wall outlet, then insert 6 size “D” batteries (not
supplied) into the battery compartment as shown.
Observe (+) and (-) polarities.
BATTERY DOOR
(on the bottom of the set)
CHOOSING THE POWER SOURCES
Install Batteries
as illustrated
NOTE: The polarized
plug has two blades with
one wider than the other.