Linak TWINDRIVE TD1 - Manual (Page 5)

Removal / fi tting of the 9V batteries:
Changing of the 9V batteries is possible by pushing the batteries upwards via the two holes in the bottom of the unit.
It is necessary to use a blunt instrument with a diameter of Ø6 mm. When the batteries are visible from above they can be
removed by using fi ngers.
Important, before removal remove the battery clips. Fitting is done by pushing the batteries into the holes remembering
that the clips must be uppermost and that they are fi rst connected when the batteries are in place.
If the battery option is chosen the system will be able to be lowered into the reset position by using the reset button on the
handset during power failure.
This function is only available for the head and foot rest and only when the emergency lowering function is an available
option.
Initialisation of the TD1 memory and infrared system.
To ensure optimum drive of the systems with memory, infrared and extra channels must be
run out to the outward position and in again before use. This drive (out + in) must be done
without stops.