Lincoln Electric IMVERTEC V160-T - Manual (Page 25)

C-1 ACCESSORIES C-1
OPTIONAL ACCESSORIES
AND COMPATIbLE EQUIPMENT
Factory Installed
1-Twist-Mate Torch Connector (W/Gas Pass Through)
1- Ground Lead and Plug Assembly
Strap Packet
Instruction Manual
Field Installed
K870 - Foot Amptrol tm for TIG welding. When the
V160-T’s Output Control is in the “REMOTE” position,
the foot Amptrol energizes the output and controls the
output remotely. The Foot Amptrol connects directly
to the 6 pin Amphenol.
K963-3 - Hand Amptrol tm for TIG welding. When the
V160-T’s Output Control is in the “Remote” position,
the hand Amptrol energizes the output and controls
the output remotely. The Hand Amptrol connects
directly to the 6 pin Amphenol.
K814 - Arc Start Switch - Energizes the output for
TIG welding if remote output control of the amperage
is not desired. It allows on/off TIG welding at the cur-
rent set by the Current Control on the control panel.
When using the Arc Start Switch set the Output
Control to the “LOCAL” position.
Magnum® PTA-9 and PTA-17 TIG Torches - The fol-
lowing standard Magnum® TIG torches with one-piece
cable may be used with the Invertec V160-T.
• K1781-1 PTA-9 12.5 ft medium back cap
• K1781-3 PTA-9 25 ft medium back cap
• K1782-1 PTA-17 12.5 ft long back cap
• K1782-3 PTA-17 25 ft long back cap
NOTE: Each torch requires a Twist-Mate
adapter,(one is included with the machine).
Collets, collet bodies, and nozzles are not
included and must be ordered separately.
CAbLE PLUGS
K852-50 - Cable Plug Kit for 1/0-2/0 cable. Attaches
to welding cable to provide quick disconnect from
machine.
Twist-Mate Torch Adapter K1622-1 - One is shipped
with the welder to connect the Magnum PTA-9 torch. If
you do not care to interchange this part between
torches (one is required to connect Magnum PTA-9 or
PTA-17 TIG torches with one-piece cable to the V160-T)
you may order an additional adapters. The quick con-
nect plug provides connection for both gas and weld-
ing current.
TIG Torch Parts Kits - Parts kits are available for the
PTA-9 and PTA-17 TIG torches. These kits include
back cap, collets, collet bodies, nozzles and tung-
stens.
Order KP507 for PTA-9 torches
Order KP508 for PTA-17 torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals
are available for welding stainless steel, mild steel,
aluminum and copper alloys. See publication C9.10.
V160-T