Land Pride AFM4014 - Manual (Page 22)

20
Section 3: Adjustments
AFM4011, AFM4014 and AFM4016 All Flex Grooming Mowers 315-160M 7/28/06
Land Pride
Table of Contents
Section 3:
Adjustments
Center Deck Height Adjustments
!
DANGER!
Before making adjustments or performing maintenance on your
mower, disengage PTO, shut off tractor and wait for all moving
parts to stop before dismounting tractor. Disconnect the PTO
driveline.
!
CAUTION!
Block the decks before making cutting height adjustments.
These adjustments should be made with the mower
hooked up to the same tractor that will be used for field
operations or one having the same drawbar height.
Position the mower on a level surface and hitch adjusted
so the main frame is level to the ground. Tire pressure
will affect mowing height. Be sure all tires have the
proper pressure as listed in the Tire Inflation Chart under
the “Appendix” section on page 46.
Refer to U-Joint Timing and Transporting in the
“Operating Instructions” on page 16 for instructions on
raising and lowering the decks before continuing.
1. Raise the decks up to an adequate height and block
under the decks to prevent them from falling during
gauge wheel height adjustments. Locate equal
number of spacers below the spindle tubes on all 10
gauge wheels. see also note after this step.
•
Refer to Figure 3-1 for Minimum Cutting Height Set-
up and Maximum Cutting Height Set-up.
•
Refer to the Cutting Height Chart on this page for a
guide on measuring cutting height.
Figure 3-1
12717
12716
Minimum Cutting Height Set-up
Approximately 1” for Model 4011
Approximately 3/4” for Models 4014 & 4016
Maximum Cutting Height Set-up
Approximately 5 1/2” for Model 4011
Approximately 5 1/4” for Models 4014 & 4016
Cutting Height Chart
4011 Models 4014 & 4016
A B A B
4 7/8" 1" 4 5/8" 3/4"
5 3/8" 1 1/2" 5 1/8" 1 1/4"
6 3/8" 2 1/2" 6 1/8" 2 1/4"
7 3/8" 3 1/2" 7 1/8" 3 1/4"
8 3/8" 4 1/2" 8 1/8" 4 1/4"
9 3/8" 5 1/2" 9 1/8" 5 1/4"
12742