Land Pride Accuz Z52 - Manual (Page 11)

9
Section 1 Assembly and Set-Up
03/11/03 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M
Land Pride
Accu-Vac Assembly
Refer to Figure 1-9 on page 12
Land Pride offers as an option an Accu-Vac Collection
System designed to collect mower clippings into two 30
gallon rubber containers mounted on the back of the
mower.
!
WARNING!
Do not operate Accu-Vac System without remote air cleaner set-
up or engine damage may occur.
!
WARNING!
Do not operate mower without deflector chute or Accu-Vac in
place.
Mower Deck Preparation
Refer to Figure 1-6:
Park the Accu-Z mower on a flat surface. Shut off the
ignition switch and remove the key from the switch.
Disconnect the negative battery cable.
Before the Accu-Vac can be installed, the right side pulley
cover (4) and discharge chute assembly (1) must be
removed. Loosen the tensioner for the blade belt and
remove pulley (7). Parts 2, 3, 6 and 8 will be used to
assemble Accu-Vac.
NOTE: Accu-Vac Collection System cannot be
mounted on Accu-Z mowers manufactured with
Honda engines. Use only with Kawasaki engines.
NOTE: Retain all other parts as they will be re-installed
when the Accu-Vac is removed.
Chute, Pulley and Pulley Cover Removal
Figure 1-6
19907