Logic 3 V5.00 - Manual (Page 75)

Notify All / First
Allows you to select if all client connections receive motion alarm notifications or only
the client connection at the top of the list.
Connection
Attempts
The number of attempts to retry sending a motion alarm to a client connection.
Retry Delay Number of seconds to wait between retries.
Video Loss Tab 2.1.9
If the video signal is lost from an enabled camera, you can specify an action to take in the “Video Loss” tab.
Video Loss Mode
Active Signal
Detection
Enables hardware signal loss detection if the capture card has support for this
feature.
Sensitivity Allows adjustment of the software signal loss detection algorithm.
Blank Camera
Detection
Enables software signal loss detection. Can be used in addition or in place of
hardware signal loss detection.
Record Blank
Camera
Enables the DVR to continue recording during signal loss detection events. Normal
operation turns off recording for video feeds with no signal detected.
Video Loss Email Notification
Enabled
Enables email notification for video loss events for the selected camera. Click “Email
Settings…” to configure email settings and email notification recipients.
Video Loss Trigger
Enabled
Enables an output relay to be triggered when a video loss is detected for the selected
camera.
Output Relay Specifies which detected relay to trigger.
Trigger
There are two trigger types: a momentary trigger of 2 seconds or a latched trigger
which will stay triggered until video feed is recovered.
2.1.9.1 Video Loss Email Notification
When enabled and live video is lost for the selected camera, email is sent to recipients specified in the Email
Settings.
3xLogic Vigil System Server Software - User’s Guide Doc# 08100610 Page 75