Lanzar Car Audio SD43MU - Manual (Page 19)

18
Basic Operation
Setting Audio Modes
It`s depend on your habit to select the Audio mode .
SWF LUD DSP CLK MOD
VOLUME- SEL VOLUME+
ROCK
touch to select
POP
FLAT
ROCK
CLASSIC
JAZZ
Touch the screen the DSP range
(or press the EQ button on the
front panel ) to select one of the
preset sound modes DSP
(Rock/Pop/Jazz/Classic/Flat) .
The information will display in the
monitor as follow :
Balance:
Fader:
R10 to L10
Adjust sound balance between left
and right speakers by using VOL + / -
F10 to R10
Adjust sound balance between front and
rear speakers by using VOL + / VOL - .
.
FM1 106.30
MHz
ST DX
LUD SWF POP 11:08 AM DISC
In Radio mode:
You can adjust your desired scroll
caption , the method of the operation
as follow:
a). Press and hold the SETUP button
(for about 2 seconds) on the remote
control, the adjustment scroll bar
will display on the screen .
b). Use the VOL+/- to select among of
the “A, B, C ....X, Y, Z, and blank ”,
and use the / button on the
Scroll Caption Adjustment
front panel to ahead/back (proceed/
cancel) , and then press the SETUP
button briefly to confirm .
(Press it button longer again to renew . )
Following the diagram below, t o
connect analogue replay devices. Use
this jack to replay sound of other replay
equipment such as DVD players,
computers, etc. Via the loudspeakers.
1).Please connect the external device
with stereo jack(black end) plug the
Aux in socket of the unit .
2).Press the MOD button to select the
AUX IN connection.
3).With the buttons on the external
device to operate the item of the playing.
Alternate Audio/video Source
MENU
Headphones port
( connect cable)
Black
White
SWF LUD DSP CLK MOD
VOLUME- SEL VOLUME+
AUX IN
SWF POP 11:08 AM DISC
touch to select