Lenovo THINKCENTRE 8177 - Manual (Page 134)

6. Install the new power supply and insert the four screws that hold the power
supply in place.
7. Reconnect all power supply cables to the system board and the drives. See
“Identifying parts on the system board” on page 124.
8. Go to “Closing the cover and connecting cables” on page 133.
Removing and replacing the system board
1. Remove the cover. See “Removing the cover” on page 121.
2. Remove any PCI adapters installed. See “Removing and replacing a PCI
adapter” on page 125.
3. Carefully take note of the location of all cable connections on the system
board. It will be necessary to reconnect them properly when installing a new
system board. See “Identifying parts on the system board” on page 124.
4. Remove any air baffles or ducts.
5. Disconnect all cables connected to the system board.
6. Remove the screws that secure the system board in place and remove the
system board.
128 Hardware Maintenance Manual