Lantronix MSS - Manual (Page 43)

Command Reference Change NetWare Internal Network
2-34
Parameters Ether_II
Enables Ethernet v2 frame type.
Native
Enables the “native mode” NetWare frame type.
Snap
Enables the 802.2 frame type with SNAP SAPs.
802_2
Enables the 802.2 frame type with NetWare SAPs.
Defaults all Enabled (Internal routing also enabled)
See Also Change NetWare Internal Network, page 2-34; Change NetWare Routing,
page 2-35; Show NetWare, page 2-64.
2.37 Change NetWare Internal Network
Changes the MSS’s preset internal network number, which is derived from the unit’s Ethernet address. This
number is used for internal NetWare routing.
Restrictions Requires privileged user status.
The MSSLite, MSS4, and the MSS-VIA do not support Netware.
Parameters number
Specify the new internal network number in the format annnnnnn where a
represents a letter and each n represents a number.
See Also Change NetWare Encapsulation, page 2-33; Change NetWare Routing, page
2-35; Show NetWare, page 2-64.
2.38 Change NetWare Loadhost
Specifies the name of the fileserver from which download attempts will be made at boot time.
Restrictions Requires privileged user status.
The MSSLite, MSS4, and the MSS-VIA do not support Netware.
CHANGE NETWARE INTERNAL NETWORK number
CHANGE NETWARE LOADHOST
fileserver
NONE