Listen Technologies PS 6000 - Manual (Page 7)

Danish Interpretation Systems User Manual
Manual 01 18 04450 7
Operating instructions
PS 6000 Power Supply
General description
The PS 6000 Power Supply provides additional
Power for the DCS 6000 system.
One CU 6005/6010 Central Unit is needed in each
DCS 6000 system; however for expansion of the
system the PS 6000 Power Supply is suitable. The
PS 6000 consists of:
•
One Power Supply
•
Control electronic for detecting system power
Features
The main features of the PS 6000 Power Supply
are:
•
Built in Power Supply for app 60 units
(Delegates) or app. 150 Channel Selectors
•
One connector for connection to Delegate
Units, Interpreter Units etc.
•
One connector for connection previous unit (i.e.
CU 6005/6010.
•
Delayed switching on of power to minimise the
total ‘switch-on’ current on the Mains supply.
•
Designed in a small size easy-to-install cabinet.
Connectors
The PS 6000 Power Supply features the following
connectors:
Power connector
Connection for main power.
Loop through connectors
RJ45 connector, 2 pieces
DCS-LAN connectors used for connection to the
CU 6005/6010 and for connection to other units
with DCS-LAN connectors such as more PS 6000.
Power LED
Those green LED light up when Power is available
on the connector next to the LED.
System design
There are no settings to be done on the PS 6000
Power Supply.
However it is important to observe, that the unit is
only adding power to one of the chains on the CU
6005/6010 Central Unit.
And as so, the specification, which applies the two
chain outputs on the CU 6005 Central Unit and to
each of the chain outputs on the CU 6010 Central
Unit, does also apply to the output on the PS 6000.
And the PS 6000 is NOT a repeater, which means
that the maximum cable length in a chain (which
without repeater is 200 m) has to be calculated from
the last unit with repeater functionality (typically a
CU 6005/6010, EX 6010 or RP 6004) to the last
unit connected to the PS 6000.
This includes interconnection cables between the
units.