Lucent Technologies MDW 9000/9010 - Manual (Page 11)

9
␣Posting Messages ␣
To program:
See Programming Buttons & Settings, p. 22.
To post messages, you must program a Posted Messages button. A posted message appears on
the display of any inside caller who tries to reach you, as long as that person has a display
phone.There may be as many as 20 messages available to you for posting. Message 1 is always
DO NOT DISTURB *; 9 other messages, listed below, come with the system, but these can be
changed by your system manager. The remaining 10 messages are created by your system
manager, whom you should ask for details.
Code Message Code Message
01 DO NOT DISTURB 06 IN CONFERENCE
02 OUT TO LUNCH 07 WITH A CLIENT
03 AT HOME 08 WITH A CUSTOMER
04 OUT SICK 09 AWAY FROM DESK
05 IN A MEETING 10 OUT ALL DAY
To post a message:
Press the programmed Posted Messages button and dial the code for the message (01–20).
To cancel a posted message:
Press the programmed Posted Messages button and dial 00.
* If you use the Do Not Disturb feature (p. 15) and have a programmed Posted Messages button, the
appropriate message is posted. When you turn off the Do Not Disturb feature, the posted message is
canceled too. However, posting or canceling the message does not activate or deactivate the feature.
Messaging
␣Signaling & Notify ␣
To program:
See Programming Buttons & Settings, p. 22.
Signaling. Program a button that will cause a co-worker’s phone to beep. The other person can
then call you in response to the beep. You must program a different line button for each extension
you wish to contact. To beep the recipient’s phone, just press the button, and the other phone
beeps for as long as you hold down the button. A programmed Signaling button also acts as an
Auto Dial button (see p. 12). To dial the extension, press the On/Off button; then press the
Signaling button.
Notify. This feature simply lights a line button on the recipient’s phone, providing a silent
message light that alerts the other party to call you. To use this feature, you must program a Notify
Send button (labeled, for example, Notify Mary) on your phone and the recipient must program a
Notify Receive button (labeled, for example, Call Jim) on his or her phone. Communication is
one-way only, and buttons must be programmed for each extension you notify.