Little Wonder 8160 - Manual (Page 12)

C. Directions for removing the Fan and
Talon ring, and reinstallation
1. Remove spark plug wires from spark plug.
2. Remove hose flange assembly.
3 Remove front plate assembly.
4. Remove bolt securing fan and talon ring to engine
crankshaft.
5. Remove talon ring
6. Align notch in the front plate of the housing, and fan
blades.
7. The fan a 3/4-16 nut welded on the fan hub.
Insert a 3/4-16 x 5” long grade 5 (or better)
bolt and jack or push the fan off the engine
(Little Wonder P/no 910505 pressure screw is
recommended.)
8. Replace damages or worn fan with a new
one. If during fan removal Key (64164-13) was
removed for the keyway, reinstall it by applying
a few drops of the Loc-tite 380 instant adhesive
(“Black Max” P/no 38050) on the key, and load
the key in the keyway of the shaft. (Cure time is
approx. 1 min.)
11.
Notches in the front
plate of the housing
9. Rotate the drive shaft with installed key by pulling
the starter rope until key is aligned with one of the
notches. Then align fan keyway with the drive shaft
hey and install fan (#720220).
10. Align talon ring hole with the fan holes, and install
talon ring (#720255).
11. Apply a few drops of the Loc-tite 380 instant adhesive
(Black Max P/N 38050) on a new bolt (#720502)
and complete fan and talon ring installation. Insure a
secure fit upon re-assembling.
Aligning holes