Lenoxx Electronics HT-377 - Manual (Page 16)

IB-HT377-WM-E-050405
ON/STANDBY
MU TE SOUR CE
AMPLIFIER IN MAIN SET
REMOTE CONTROL CONTROL PANEL
(ON THE FRONT OF THE SUBWOOFER)
General
1
Make sure the POWER switch on the back of the main set is at “ON” position. Next press the
ON/STANDBY button on the front of the main set or on the REMOTE CONTROL to turn the set
on (or standby).
NOTE: The STANDBY indicator has 2 modes: flashing and steadily on (slow flashing
indicates the set is in standby mode, steadily on indicates the set is on). When the set
is on, pressing the ON/STANDBY button on the main set or on the REMOTE
CONTROL will turn the set to the standby mode, the indicator will become slow
flashing.
2
Press the SOURCE button on the front panel of the main set or on the REMOTE CONTROL
to select one of the audio input sources, the corresponding indicator will light, the factory’s
default input source is DVD, when the set is turned on, the DVD indicator will be on.
3
For volume adjustments, press the volume control buttons on the Remote control, the ON/
STANDBY indicator will flash to show you that the remote signal is received.
4
To momentarily shut off the sound, press the MUTE button. The source indicator (DVD or
MP3) will flash. Press the MUTE button again or press the VOLUME buttons to restore the sound.
NOTE: Flip the POWER switch on the back of the main set to “OFF” if the set will not be used
for a long period of time (several days or more).
ON/STANDBY
button
MUTE
button
SOURCE
button
VOLUME -
button
VOLUME +
button
ON/STANDBY
button
ON STANDB Y
VOL
VOL
SOURCE
DVD
MP3
ON/STANDBY
indicator
VOLUME +
button
VOLUME -
button
SOURCE
button
DVD
indicator MP3
indicator
NOTE: Every time you turn the set on, the VOLUME will go back to the factory’s default
setting; and whenever you press the SOURCE button on the main unit or on the REMOTE,
the VOLUME will go back to the factory’s default setting. This avoids sudden very loud
sounds from startling you.
15
IB-HT377-WM-E-050405.pmd 6/2/2005, 2:15 PM 16