Safety instructions, Precautions – Lenoxx Electronics HT-377 User Manual

Page 3

Advertising
background image

IB-HT377-WM-E-050405

CAUTION

FCC Regulations state that unauthorized changes or modifications to this equipment may
void the user’s authority to operate it.

FCC NOTE

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect this equipment into an outlet on a circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced radio/TV technician for help.

SAFETY INSTRUCTIONS

Please read important information displayed on the rating plate located on the bottom enclosure
before connecting to AC Mains or any operation.

2

PRECAUTIONS

ON SAFETY

Should any solid object or liquid fall into the Home Theater System, unplug the player,
and have it checked by qualified personnel before operating it any further.

ON PLACEMENT OF YOUR HOME THEATER SYSTEM

Do not leave the Home Theater in a location near a heat source, or in a place subject to
direct sunlight, excessively dusty rooms or r ooms with v ery high humidity.

Do not place the Home Theater system on an inclined or unstable place.

Do not place anything within 1 inch of the sides or 2 inches from the back of the
cabinet. The heat sink fins must not be covered for the set to operate properly and
prolong the life of its components.

IB-HT377-WM-E-050405.pmd

6/2/2005, 2:15 PM

3

Advertising