LOREX Technology LW2100 - Manual (Page 13)

Wireless Receiver
9
Wireless Receiver
1. Wireless Antenna: Screws onto to the top of
the receiver.
2. Channel LEDs: When lit up, indicates the
current viewing mode.
3. Resolution* button: Press to switch
between VGA and QVGA video resolutions;
press and hold for several seconds to
remove/replace channels from Auto-Scan.
See page 14 for more details.
4. Front LED: Lit in green to indicate power to
the receiver.
5. Channel: Press to change channels (1~4),
Quad split-screen mode, and Auto-Scan
viewing mode; press and hold to add (pair) a
new camera to the receiver.
Connecting the Camera
Before you install the camera, carefully plan where and how it will be positioned, and where you will
route the cable that connects the camera to the power adapter.
• Before starting permanent installation, verify its performance by observing the image on a
monitor when camera is positioned in the same location/position where it will be permanently
installed.
*VGA mode has a resolution of 640 X 480 pixels; QVGA mode has a resolution of 320 X 240 pixels. Use VGA
mode for best video performance. Use QVGA mode if you need a higher video frame rate.
VGA
/
QVGA Pair
4
2
3
5
1