LOREX Technology LW2100 - Manual (Page 14)

Connecting the Camera
10
Installation Warnings:
• Aim the Cameras to best optimize the viewing area: Select a location for the camera that provides
a clear view of the area you want to monitor, which is free from dust, and is not in line-of-sight to
a strong light source or direct sunlight.
• Avoid installing the cameras where there are thick walls or obstructions between the Cameras
and the Receiver*.
• Select a location for the camera that has an ambient temperature between 14°F~122°F
(-10°C~50°C)
Installing the Camera
To install the camera:
1. Use the included mounting screws
to mount the stand to the mounting
surface:
• Mark the position of the screw holes
on the wall
• Drill holes and insert the drywall
plugs as needed
• Firmly attach the stand to the wall
using the provided screws
2. Attach the camera to the mounting
stand. Adjust the angle of the
camera until the desired view is set.
Tighten the thumbscrews to secure
the desired camera position.
3. Connect the power cable from the
camera to the Power Adapter; plug
the Power Adapter to an outlet or
surge protector.
NOTE: You can add additional cameras
(maximum of 4 cameras). When adding
cameras that were not included in the
original box, you will need to pair up the
cameras with the receiver. Refer to the
camera pairing section of this manual
for more details.
Figure 1.1 Attach the camera to the stand
Figure 1.0 Attach stand to mounting surface
*Avoid installing in a location which requires the wireless signal to pass through cement, concrete, and
metal structures. This will reduce the range of transmission.