Lincoln Electric Mobiflex 400-MS - Manual (Page 13)

A-6 INSTALLATION
MOBIFLEX 400-MS
A-6
INSTALLING THE OPTIONAL
LAMP KIT AND AUTOMATIC
START/STOP ARC SENSOR
(continued)
Route the 13 ft. connecting cable through the four
cable holders in the arm (Fig. 12, Points D). Leave
plenty of slack at each hinge to allow for the full range
of movement of the arm. Secure the cable in the
cable holders (Fig. 12, Inset). Exit the arm through the
cable hole in the rotating hinge; use a knife to cut a
small X-pattern in the grommet and push the cable
through.
Use the supplied wire ties to secure the cable as
shown in Fig. 13.
Seal all hose joint connections with the rubber seals.
L=min. 22"
(550 mm)
Fig. 13
D D
4x
A B A
C A
D
D
Fig. 12