Operation – Lincoln Electric WELDANPOWER 125 IM530-C User Manual

Page 22

Advertising

OPERATION

–

WELDANPOWER 125

Select the appropriate electrode. See Table B.2 or
the ELECTRODE SELECTION GUIDE on the
machine Output Control Panel.

Attach the work clamp securely to the work you are
welding.

Insert the electrode into the electrode holder.

Set the current control dial to the desired output
current.

Start the gasoline engine. See ENGINE
OPERATION in this section of the manual.

Strike an arc and begin welding.

AFTER YOU FINISH THE WELD:

Stop the gasoline engine. See ENGINE
OPERATION in this section of the manual.

Allow the electrode and work to cool completely.

Remove the work clamp from the work.

Remove any remaining piece of electrode from the
electrode holder.

If you are finished using the WELDANPOWER 125
for welding, disconnect the welding cables from the
weld output terminals. Reattach the flange nuts and
leave them on the terminals.

For DC+ welding, the electrode cable is to be connected
to the “+” output stud and work cable to the “-” output
stud. (For DC- welding, reverse these connections.)

(For Codes 11183, 11406 Only)

Semi-automatic Wire Welding with a
Lincoln Wire Feeder/Welder

The Weldanpower 125 generator power can be used to
supply up to 4,250 watts continuous input power to a
Lincoln Wire Feeder/Welder. The Wire Feeder/ Welder is
equipped with all the supplies needed for Flux-Cored Arc
Welding (FCAW). Also some Wire Feeder/Welders come
equipped with the essentials needed for Gas Metal Arc
Welding (GMAW) or MIG processes, while others require
the purchase of a conversion kit. These products are
available where Lincoln products are sold. Contact your
local authorized Lincoln representative for more details.

(For Codes 11183, 11406 Only)

Plasma Cutting with Lincoln Pro-Cut 25.

The Weldanpower 125 generator power can be used to
supply up to 4,250 watts continuous input power to a
Pro-Cut 25. The Pro-Cut will work satisfactorily under the
following conditions:

1. Set the Rheostat on the Weldanpower 125 to the

125 amp position. (Higher Settings may result in a
shutdown of the Pro-Cut 25.)

2. Leave the "ON/OFF" switch on the Pro-Cut "OFF"

until the Weldanpower 125 has been started and is
at full operating speed.

120V Receptacle Operation:

• Set the Output Control on the Pro-Cut 25 no higher

than the 15 amp position.( Higher settings may cause
circuit breaker on the Weldanpower 125 to trip.)

• Maximum material thickness that can be cut is 1/4".

240V Receptacle Operation:

• The Pro-Cut 25 may be used for its full range of

control.

• Maximum material thickness that can be cut is 3/8".

(Codes 10158, 10160 Only)

Semi-automatic Wire Welding with a Lincoln Wire
Feeder/Welder

The Weldanpower 125 generator power can be used to
supply up to 4,500 watts continuous input power to a
Lincoln Wire Feeder/Welder. The Wire Feeder/ Welder is
equipped with all the supplies needed for Flux-Cored Arc
Welding (FCAW). Also some Wire Feeder/Welders come
equipped with the essentials needed for Gas Metal Arc
Welding (GMAW) or MIG processes, while others require
the purchase of a conversion kit. These products are
available where Lincoln products are sold. Contact your
local authorized Lincoln representative for more details.