Lanier 1027 - Manual (Page 225)

Replacing Photo Conductor Unit (PCU)
213
5
EEEE
Raise the green handle and slide the photo conductor unit out towards you.
Important
❒ Do not tilt or drop the removed photo conductor unit. Moving the unit
abruptly can scatter the toner.
❒ While the photo conductor unit is removed, do not change the toner.
FFFF
Take the new photo conductor unit from the box and remove the plastic
bag, holding the handle.
Important
❒ Do not drop or damage the removed photo conductor unit.
❒ Do not touch the side of the photo conductor unit.
GGGG
Put the photo conductor unit removed in step
EEEE
into the plastic bag emptied
in step
FFFF
, keeping the unit at the same angle as when it was installed. Then,
zip the plastic bag.
Note
❒ Do not tilt the used PCU after removing it from the machine. If you do, ton-
er might fall.
HHHH
Remove the two red sheets from the photo conductor unit in the order
shown in the illustration.