Lanier 1027 - Manual (Page 216)

User Tools (Copy/Document Server Features)
204
4
Input/Output
❖ ❖ ❖ ❖ Switch to Batch (SADF)
You can select whether Batch mode or SADF mode is displayed when you
press the Special Original key.
❖ ❖ ❖ ❖ SADF Auto Reset
When you set one original at a time in the document feeder, the Auto Feed
indicator lights for a selected time after an original is fed to show that the doc-
ument feeder is ready for another original. You can adjust this time from 3
seconds to 99.
Note
❒ Default: 5sec.
❖ ❖ ❖ ❖ Rotate Sort: Auto Paper Continue
You can specify whether to continue copying when the paper of the required
orientation has run out during rotate-sorting.
⇒ "Rotate Sort" on p.47 “Sort”
• If you select [No]:
When paper of the required orientation runs out, the machine stops copy-
ing and prompts you to supply copy paper. When you load paper, the ma-
chine will continue copying.
• If you select [Yes]:
Copying continues using copy paper of a different orientation. The copy
job will finish even if you have left the machine.
Note
❒ Default: No
❖ ❖ ❖ ❖ Auto Sort
You can specify whether Sort mode is selected when the machine is turned on
or the mode is cleared.
Note
❒ Default: No
❖ ❖ ❖ ❖ Memory Full Auto Scan Restart
When the memory becomes full while scanning originals, the machine can
make copies of the scanned originals first, and then automatically proceed
scanning the remaining originals.
You can enable or disable this function.
• If you select [No]:
When the memory becomes full, the machine stops operation allowing you
to remove the copy pages delivered on the output tray.
• If you select [Yes]:
You can leave the machine unattended to make all the copies, but the re-
sulting sorted pages will not be sequential.
Note
❒ Default: No