Lanier 1027 - Manual (Page 221)

Where to Put Your Machine
209
5
Limitation
❒ Carefully move the machine. If
you do not, the machine might be
damaged or a stored file might be
deleted.
❒ Do not take off the holding stand.
❒ Avoid any strong shock to the ma-
chine. This could damage the hard
disk and cause stored files to be de-
leted. For precautionary reasons,
files should be copied to another
local computer.
Power Connection
R WARNING:
R CAUTION:
R CAUTION:
• When the main switch is in the
Stand-by position, the optional
anti-condensation heaters are on.
In case of emergency, unplug the
machine's power cord.
• When you unplug the power cord,
the anti-condensation heaters turn
off.
• Make sure that the plug is firmly
inserted in the outlet.
• Voltage must not fluctuate more
than 10%.
• The socket-outlet should be in-
stalled near the equipment and
should be easily accessible.
Access to the Machine
Place the machine near the power
s o u r c e , p ro v i d i n g c le a ra n c e a s
shown.
1. Rear: more than 1 cm (0.4")
2. Right: more than 1 cm (0.4")
3. Front: more than 75 cm (29.6")
4. Left: more than 1 cm (0.4")
Note
❒ For the required space when op-
tions are installed, contact your
service representative.
• Only connect the machine to
the power source described on
the inside front cover of this
manual. Connect the power
cord directly into a wall outlet
and do not use an extension
cord.
• Do not damage, break or make
any modifications to the power
cord. Do not place heavy ob-
jects on it. Do not pull it hard
nor bend it more than neces-
sary. These actions could
cause an electric shock or fire.
• Unplug the power cord from the
wall outlet before you move the
equipment. While moving the
equipment, you should take care
that the power cord will not be
damaged under the equipment.
• When you disconnect the power
plug from the wall outlet, always
pull the plug (not the cable).
2
1
3
4