Lanier 1027 - Manual (Page 73)

Copying from the Bypass Tray
61
2
Copying from the Bypass Tray
The optional bypass tray is required to use this function.
Use the bypass tray to copy onto spe-
cial paper (OHP transparencies, label
paper (adhesive labels), thick paper
(for example postcards and enve-
lopes), thin paper) , and copy paper
that cannot be loaded in the paper
trays.
Preparation
When copying from the bypass
tray, select [1 Sided] for copying in
[Dup./Combine/Series]
(for example
[1 Sided]
→[1 Sided] or [2 Sided]→[1
Sided] ).
Note
❒ The machine can automatically de-
tect the following sizes as standard
size copy paper.
❒ If you do not use the standard size
copy paper or if you use special pa-
per, you should input vertical and
horizontal dimensions.
⇒ p.22
“Copy Paper”, p.63 “When copy-
ing onto custom size paper” The
sizes that you can input are as fol-
lows.
*1 Paper size up to 600mm(23.6") is
available when an optional HDD is
installed.
❒ When using paper larger than 433
mm in size, load it so that it is fed
straight into the machine.
❒ When paper larger than 433 mm in
size is used, the paper may become
wrinkled, may not be fed into the
machine, or may cause paper jams.
❒ The maximum number of sheets
you can load at the same time de-
pends on the paper type. For de-
tails about the paper capacity of
the bypass tray,
⇒ p.22 “Copy Pa-
per”.
❒ Some kinds of envelopes might
cause misfeeds and wrinkles. In
this case, push down the green le-
ver of the fusing unit.
⇒ p.65
“When copying onto envelopes”
Also, be sure to place the front face
of the envelope downwards.
AAAA
Open the bypass tray.
Metric
version A3 L , A4 L , A5 L , 8"
× 13" L
Inch
version 11" × 17" L , 8 1 /
2
" × 14" L ,
8 1 /
2
"
× 11" L , 5 1 /
2
"
× 8 1 /
2
" L
Metric
version • Vertical: 90 – 305mm
• Horizontal: 148 – 432mm *1
Inch
version • Vertical: 3.6" – 12.0"
• Horizontal: 5.9" – 17.0" *1