Size magnification, 2size magnification – Lanier 1027 User Manual
Page 91
Size Magnification
79
2
Size Magnification
This function calculates an enlarge-
ment or reduction ratio based upon
the lengths of the original and copy.
Preparation
Measure and specify the lengths of
the original and copy by compar-
ing "A" with "a."
Limitation
❒ If the calculated ratio is over the
maximum or under the minimum
ratio, it is adjusted to within the
available range of ratios automati-
cally. However, with some ratios,
parts of the image might not be
copied or margins will appear on
copies.
Note
❒ A ratio is selected in the range of 25
to 400% (25-200% when placing
originals in the document feeder).
AAAA
Press the [Reduce/Enlarge] key.
BBBB
Press the [Specifd. Ratio] key.
CCCC
Make sure that the [Specifd. Ratio]
key is highlighted.
DDDD
Enter the length of the original
with the number keys, and then
press the [#] key.
Note
❒ You can enter sizes within the
following ranges.
❒ To change the length entered,
press the [Clear] or
{
{
{
{
Clear/Stop
}
}
}
}
key and enter the new length.
Amm
amm
Metric
version
1 – 999mm (in 1mm steps)
Inch
version
0.1" – 99.9" (in 0.1" steps)