Lanier 1027 - Manual (Page 95)

Directional Size Magnification (Inch)
83
2
Directional Size Magnification (Inch)
The suitable reproduction ratios will
be automatically selected when you
enter the horizontal and vertical
lengths of the original and copy im-
age you require.
1: Horizontal original size
2: Vertical original size
3: Horizontal copy size
4: Vertical copy size
Preparation
Specify the vertical and horizontal
sizes of the original and those of the
copy, as shown in the illustration.
Limitation
❒ If the calculated ratio is over the
maximum or under the minimum
ratio, it is adjusted to within the
available range of ratios automatical-
ly. However, with some ratios, parts
of the image might not be copied or
margins will appear on copies.
Note
❒ You can enter sizes within the fol-
lowing ranges.
❒ The reproduction ratios that you
can specify are 25-400% (25-200%
when placing originals in the doc-
ument feeder).
AAAA
Press the [Reduce/Enlarge] key.
BBBB
Press the [Specifd. Ratio] key.
CCCC
Press the [Dirc.Size Mag.In] key.
DDDD
Enter the horizontal size of the
original with the number keys,
and then press the [#] key.
Note
❒ To change the value entered,
press the [Clear] or { { { {
Clear/Stop
} } } }
key and enter the new value.
Metric
version Vertical: 1 – 999mm (in 1mm
steps)
Horizontal: 1 – 9999 (in 1mm
steps)
Inch
version 0.1" – 99.9" (in 0.1" steps)
1
3
2 4
CP2M01EE