Lennox Hearth H6977 - Manual (Page 2)

2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Figure 3
Step 9. Locate the fireplace control board (Kit Number H1094) and
remove it, including the plastic holders (
Refer to Figure 1 ).
Step 10. Disconnect the IR cables (ribbon type cables). Refer to
Figure 2.
Step 11. Locate the wire harness behind the right hand side frame.
Step 12. Some early units may have a metal wire shield ( Figure 3 ). Slide
the shield upwards to align the slots to the screws and remove.
Step 13. Pull the wire harness completely outside the cavity and remove
the flexible wire conduit to expose the wires completely (some early units
may have binding tape). If provided, save the flexible conduit to re-use.
Step 14. Leave the A/V cables in place. These cables are not being
replaced with the Remote Control Kit.
Refer to Figures 4 and 5.
Wire Shield
Figure 4
Bottom Side View
Figure 5
A/V Cables
Upper Side View