LSI 8751D - Manual (Page 18)

2-2 Installing the LSI8751D
Step 7. Connect the internal and external SCSI peripherals.
Optional: Connect the LED cable on your SCSI host adapter.
Step 8. Terminate the SCSI bus.
The SCSI bus requires proper termination and no duplicate
SCSI IDs.
Step 9. Set the peripheral SCSI IDs.
Step 10. Make any configuration changes.
Step 11. Replace your PC cabinet cover.
Step 12. Plug in your computer and peripherals.
Step 13. Turn on the peripherals, and then your computer.
The host adapter installation is complete.
Refer to the PCI Storage Device Management System SDMS 4.0 User’s
Guide (or the guide for the software you will use) to load the driver
software for your particular operating system. Additionally, this guide
contains documentation about the SCSI BIOS Configuration Utility, which
provides a means to change system configuration.
2.2 Detailed Installation Procedure
This section provides step-by-step instructions for installing the
LSI8751D and connecting it to your SCSI peripherals. If you are
experienced in these tasks, you may prefer to use the instructions in the
preceding
Section 2.1, “Quick Installation Procedure.”
2.2.1 Before You Start
Before starting, read through the steps defined within the detailed
installation procedure. If you are not confident that you can perform the
tasks as described in this section, LSI Logic suggests getting assistance.
The SCSI host adapter acts on your computer’s behalf as the host to
your suite of SCSI peripherals. Each chain of SCSI peripheral devices
and their host adapter work together and are referred to as a SCSI bus.
Each channel on your SCSI host adapter can act as host for up to
15 peripheral devices, not including the adapter itself.