5 setting scsi ids, Setting scsi ids – LSI 8751D User Manual
Page 35
Detailed Installation Procedure
2-19
2.2.5 Setting SCSI IDs
Each SCSI device and the host adapter must have a separate SCSI ID,
0 through 15. SCSI ID 7 is the preset host adapter setting, giving it the
highest priority on the SCSI bus. If you plan to boot your computer from
a SCSI hard disk drive on the SCSI bus, that drive should have SCSI ID
0, or the lowest SCSI ID on the bus. The PCI Storage Device
Management System SDMS 4.0 User’s Guide explains how to set your
host adapter ID using the SCSI BIOS Configuration Utility.
The peripheral device SCSI IDs are usually set with jumpers or with a
switch on the peripheral. Refer to the peripheral manufacturer’s
instructions and to the user’s manual for your computer to determine the
ID of each device and how to change it. No duplication of SCSI IDs is
allowed on a SCSI bus. Follow these steps for setting SCSI IDs:
Step 1.
Determine the SCSI ID of each device on the SCSI bus. Note
any duplications.
Step 2.
Make any necessary changes to the SCSI IDs and record the
IDs for future reference. Correct any duplications at this time.
is provided as a place to keep this record.