Linear M3300CD - Manual (Page 6)

6
Loading and Ejecting a CD
Insert a CD into the CD Slot, label side up, and the
CD will begin to play.
Press the EJ button to stop CD play and eject the
CD from the slot.
Inserting the SD Card or USB Device
Insert the SD card into the SD card slot and insert
a USB memory into the USB input. The mode will
automatically change to SD or USB mode.
To remove the SD card:
Push in on the SD card until you hear a click,
then release the SD card and remove it.
To remove the USB memory:
Pull the USB memory out of the USB input.
Note: This unit may not play all SD cards or USB
memory devices. The manufacturer of this unit
is not responsible for any data loss. We suggest
you back-up your data.
Select Tracks
Press the �� l or l �� button for less than a
second to move to the next or previous track. The
track number appears in the display area.
Fast Forward and Fast Reverse
Press the
��
l or l
��
button for more than one
second to fast forward or fast reverse. CD play
starts from when you release the button.
Pause Play
Press the 1/ � ll button to pause play. Press it
again to resume play.
Repeat the Same Track
Press the 2/RPT button to continuously repeat
the same track. Press it again to stop repeat.
Note: After finishing all tracks or all folders the unit
restarts playing all tracks for all folders automatically.
Intro Scan
Press the 3/INT button to play the first ten sec-
onds of each track. Press it again to stop intro
scan and listen to the track.
Play All Tracks in Random Order
Press the 4/RDM button to play all tracks in random
order. Press it again to stop playing in random order.
Track Skip Buttons
Press the 5/-10 button to skip down 10 tracks.
Press the 6/+10 button to skip up 10 tracks.
CD, USB and SD Card Operation
General Operations
Turning the Unit On
Press any button to turn on the unit. Press and
hold PWR button to switch the unit off.
Mode:
Press the MODE button to change the operating
mode as follows:
RADIO > CD* > USB* > SD* > AUX > TUNER.
*Available only when there is media inserted
into Disc slot, SD card slot or USB slot.
Setting the Clock
Press the DIS button so the clock is displayed.
Press the button again and hold for 3 seconds
until the time flashes, then release. Then press
the �� l button to adjust the minutes, and press
the l
��
button to adjust the hours.
12 hr (am/pm) or 24 hr (military) Format
Press and hold the VOL knob for a few sec-
onds then release. Continue to press the knob
until “12 HOUR” appears in the display. Rotate
the VOL knob until “24 HOUR” appears in the
display. The unit will leave feature programing
after 5 seconds of no button activity.
Display Button
The display feature allows you to see the clock
and information for the current operating mode.
Each press will change the information displayed.
Audio Beep
Press and hold the VOL knob for a few seconds
then release. Continue to press the knob until
“BEEP 2ND” appears in the display. Rotate the
VOL knob to select the desired beep mode:
BEEP 2ND = Beep on Press and Hold
BEEP ALL = When Pressing any Button.
BEEP OFF = No Beep Sound.
The unit will leave feature programing after 5
seconds of no button activity.
3.5mm Auxiliary Input Jack
Plug an audio device into this jack. This allows
you to listen to an auxiliary audio source (MP3
player, portable cassette player, etc). Connect
the proper cable (not supplied with this unit).
Press the MODE button until “AUX” appears in
the display to access the auxiliary device’s audio.
Note: The M3300CD will not control the auxiliary
audio source.