Laser DVBT-ST35 - Manual (Page 10)

DVBT-ST35 User Manual
10 11
Step 5: Setting up the DVB-T Radio
If you have tuned the device to DVT-TV channels, the device will have stored all DVB-T Radio channels
detected during the scan. It will not be necessary to rescan for Radio channels. If the device has not been
used before, please use the following steps to tune the device to the DVB-T Radio broadcasts in your area.
1. Double tap the DVT-T Radio ICON in the main menu to start the Digital TV-Radio service.
2. As no channels have been stored, the channel bar should read “No Channel”.
3. Tap the [MENU] button on the lower left hand side of the screen.
4. Tap the [EXIT] Button to start the “First Time Instillation Wizard”.
5. Tap the [OK] Button to begin.
6. If the Country and Antenna settings are incorrect, tap and select the correct setting.
7. Once all the settings are correct, tap the [START] button.
8. Once the Wizard is complete, the radio screen
will be shown.
Note: After a few seconds, the screen will go blank.
This is a power saving feature. Touch the screen
anywhere to display the screen again.
9. Tap the [ ] button or the [ ] button to switch between available channels.
10. To adjust the volume tap the [+] or [-] button as required or tap the [ ] to mute the sound. Tap again to
restore the sound.
11. To access the DVB-T system menu tap on the [menu] button.
12. To return to the Main Menu tap on the [HOME] button.