Laser DVBT-ST35 - Manual (Page 8)

DVBT-ST35 User Manual
 
QuIcK STarT GuIDe for fIrST TIme uSe
Step 1: Charging the Device
1. Connect the power adaptor to the main unit, or
connect the main unit to a PC using the sup-
plied USB cable.
2. When the battery starts charging, the Charge
LED will Glow RED.
3. When the battery is fully charged The LED will
turn off
Step 2: Turning the Device on
Press the Power button to turn on. Press again to
turn the device off.
Note: The LED will turn blue when in use. The unit
can also be used while charging. The LED will
turn purple if used when being charged. The
length of time required to charge the unit will
increase if it is being used.
Step 3: Setting up the device the first time.
1. Double tap the DVT-T ICON in the main menu to start the Digital TV service.
2. As no channels have been stored the channel bar should read “000 No Channel”.
3. Tap the [MENU] button on the lower right hand side of the screen.
4. Tap the [EXIT] Button to start the “First Time Instillation Wizard”.
5. Tap the [OK] Button to begin.
6. If the Country and Antenna settings are incorrect, tap and select the correct setting.
7. Once all the settings are correct, tap the [START] button.