Liebherr EWTN - Manual (Page 11)

A delight in freshness
WFI1051 / EWTN 2956 9
Approx. 3/4"
(19.1mm)
3/32" (2.5mm)
1 Overlay Panel
1 Overlay
Panel
2 Spacer Panel
2 Spacer
Panel
3 Backer Panel
3 Backer
Panel
1/4" (6.4mm)
W
23-5/16"
(592 mm)
21-3/4"
(553 mm)
33-5/8"
(854 mm)
37-9/32"
(947 mm)
36-1/4"
(921 mm)
38"
(965 mm)
32-37/64"
(828 mm)
31-1/2"
(800 mm)
22-3/4"
(576 mm)
H - Winecooler H - Freezer
=
W
H
Winecooler
3/8"
(9mm)
=
= =
3/8"
(9mm)
=
H
Freez
er
=
= =
= =
3-1/16" (78mm)
Window
cutout
max 25-1/2 "
(648 mm)
max17-1/2"
(445 mm)
= =
Window cutout
I
NTEGRATING
C
ABINETRY
Figure 6
with three panels, the decorative overlay panel, a
3/32" (2.5 mm) spacer panel and a 1/4" (6.4 mm)
backer panel.
Depending on your cabinet manufacturer, this could
be one panel routed for different dimensions or,
more likely, three different panels. Overlay Panels - single install - Figure 6
The overlay design line allows decorative panels to
cover the door trim for a more seamless appear-
ance that blends with the design of the room. To
achieve this look, the most common way is to work
IMPORTANT
If you are replacing the factory air vents with an
overlay, DO NOT restrict the air flow. The air flow
must be the same or greater than the factory air
vents of 31 square inches (200 cm²).
The door handles must be installed on the
overlay panels before the screw covers are
installed. If you fail to install the handles on
the overlay panels before the screw covers ,
you can damage the covers. The screw covers
are taped to the unit doors during shipping.
Use care when removing covers.
The door panel weight must not exceed
25 lb (11,3 kg).