Liebherr EWTN - Manual (Page 28)

A delight in freshness
WFI1051 / EWTN 2956 26
S
IDE
-B
Y
-S
IDE
I
NSTALLATION
Figure 25
Figure 25: To install the WFI 1051 appliances side-
by-side, proceed as follows:
- Always place the WF/WFI 1051 with the hinges
on the left-hand side (looking from the front).
Installation with SBS Ventilation Grille Set:
1. Affix the spacer (1) on the side wall of the appli-
ance – remove the protective film.
2. Push the appliances together,
- align them parallel to each other.
3. Use a level on the top to align them to the
same height:
4. Use the open-end wrench 10 mm (3) to adjust
the feet at the front of the roller base. Turn
clockwise for up and counterclockwise for down.
For the rear, turn the adjusting bolt (2) clock-
wise down and counterclockwise up.
Unpacking
Unpack the side by side installation kit and check
with the provided parts list if all parts are included.
The part numbers given in the parts list are identical
to the numbers in the respective fi gures.
For installation you will need the following tools:
Included:
- Star Key Torx® 15
- Star Key Torx® 20
- Star Key Torx® 25
- Socket Wrench 8 mm
- Open-end Wrench 10 mm
Not in package:
- Phillips (star) screwdriver
- Level
- Ruler
4