Lowrance electronic LMS 335C DF - Manual (Page 91)

83
To change the chart mode color scheme:
1. From the Sonar Page, press
MENU |
↓ to
S ONAR F EATURES
| ENT .
2. Press
↓ to
S
ONAR
C
OLOR
M
ODE
| ENT .
3. Press
↓ or ↑ to Mode Name|
ENT .
4. Press EXIT | EXIT to return to the Sonar Page.
IceView was specially designed for flasher use while stationary. This
color mode has fewer, higher-contrast colors than the default mode.
This simplified color scheme makes it easier to "see" and interpret a
fish signal when it appears on the flasher screen. For more information
on interpreting IceView signals, see page 73.
Sonar Page & Sonar Chart Display Options
The Pages Menu offers five chart display options. To access them, press
PAGES |
→ to
S ONAR
|
↓ to Option Name|
EXIT .
Pages Menu, showing sonar chart display options.
Full Sonar Chart
This is the default mode used when the unit is turned on for the first
time or when it's reset to the factory defaults.
The bottom signal scrolls across the screen from right to left. Depth
scales on the right side of the screen aid in determining the depth of
targets. The line at the top of the screen represents the surface. The
bottom depth and surface temperature (if equipped with a temperature
sensor or a transducer with a temp sensor built in) show at the top left
corner of the screen.
The FasTrack™ display shows just to the right of the scale. This
changes all echoes into short horizontal bars, replicating a flasher so-
nar. The zoom bar on the far right shows the area that's zoomed when
the zoom is in use. (See the Zoom section for more information.)