Lifescan Ultra 2 - Manual (Page 9)

Customer Service 1 800 227-8862 3
Turning your meter on
To perform a test, insert a test strip as far as it will go.
The meter will briefly perform system checks, then the
display will turn on.
or,
With the meter turned off, press and hold for two
seconds to access MAIN MENU.
Check that the screen shows solid black for two
seconds. If it does, the display is working properly.
If the meter does not power on, try changing the meter battery. See page 51.
Using the meter display backlight
When the meter is already on, press and hold
for two seconds to turn the
backlight on or off.
Turning your meter off
There are several ways to turn your meter off:
• Press and hold
for five seconds.
• Your meter will turn off by itself if left alone for two minutes.
• Go to
MAIN MENU and press or to highlight METER OFF , then press .
• Before or after completing a test, remove the test strip. If you advance from the
test result screen to the MAIN MENU by pressing , removing the strip will not
turn the meter off. Use one of the three methods above.
ƽ
CAUTION: If you see
any light areas within
the black start-up screen,
there may be a problem
with the meter. Call
Customer Service.
Settin
g up
y
our sy
stem
DCO_06344501B_OU2_OB_USe.qxd 12/21/05 8:03 AM Page 3