Lincoln Electric POWER FEED IM915 - Manual (Page 16)

A-8 INSTALLATION
POWER FEED™ 10M SINGLE WIRE FEEDER
A-8
WELDING GUNS, TORCHES AND ACCES-
SORIES
GUN RECEIVER bUSHING
The Power Feed™ 10M Single Wire Feeder comes
with a K1500-2 gun receiver bushing, for use with the
Magnum gun with a K466-10 connector kit.
MAGNUM GUN AND CAbLE ASSEMbLIES
The Power Feed™ 10M Single Wire Feeder model
will accept a number of optional gun and cable
assemblies. An example of installing the Gun and
Cable is shown in Figure A.5a with a 15 ft. (4.6m) long
Magnum gun and cable.
1. Turn off power at the welding power source.
2. Unscrew Thumb screw on Wire Drive Unit, until tip
of screw no longer protrudes into gun bushing hole
as seen from the front of machine.
3. Fully insert the gun cable connector end into the
gun receiver bushing and gently tighten the thumb
screw as show in Figure A.5a below.
4. Connect the gun trigger connector to the trigger
receptacle. Make sure that the key ways are
aligned, insert and tighten retaining ring.
WIRE DRIVE UNIT
THUMB SCREW
GUN RECEIVER BUSHING
TRIGGER RECEPTACLE
GUN TRIGGER
CONNECTOR
CABLE CONNECTOR
END K466-10
FIGURE A.5a
GUN NOZZLE
GUN HANDLE GUN TUBE
GUN AND CABLE