Operation – Lincoln Electric POWER FEED IM915 User Manual
Page 26
b-4
OPERATION
b-4
ITEM
DESCRIPTION
1
Status LED indicates system status.
2
Digital Meter Display is a bright LED display of key welding information. Adjusting Parameter
Knobs.
3
MSP4 Panel is used to set the weld mode, adjust the arc, change arc start/end parameters
and for set-up information.
4
Cold Feed - Gas Purge Switch, press the switch up to feed wire with weld output off. Press the
switch down for gas flow with weld output off.
5
2 step - 4 step Switch is used to choose between a 2 step trigger or a 4 step trigger operation.
6
Location for Optional Memory Panel. (Order K2360-1 for the memory panel. See Accessories
Section).
7
Cover for Optional Water Cooling Kit, remove when the water cooling kit is installed. See
instructions with water cooling Kit.
8
Trigger Connector 5-pin amphenol for connecting the MIG gun trigger. See Installation Section
for detail.
POWER FEED™ 10M SINGLE WIRE FEEDER
2
6
3
5
1
4
7
8
FRONT PANEL CONTROLS AND CONNECTIONS
CASE FRONT CONTROLS
FIGURE b.1