Liebert Air Cooled - Manual (Page 17)

Inspection and Installation
13
3.0 I
NSPECTION AND
I
NSTALLATION
3.1 Equipment Inspection
Before unpacking the condenser, verify that the labeled equipment matches the bill of lading. Care-
fully inspect all items for damage, either visible or concealed. Report any damage immediately to the
carrier and your local Liebert representative. File a damage claim with the carrier and send a copy to
your local Liebert representative.
3.1.1 Packing Material
All material used to package this unit is recyclable. Please save it for future use or
dispose of the material appropriately.
SAFETY INFORMATION
NOTICE
Risk of overhead interference. Can cause unit and/or structure damage.
Refer to the installation plans prior to moving the unit to verify clearances.
NOTICE
Risk of damage from forklift. Improper handling with the forklift. Can cause exterior and/or
underside damage.
Keep tines of the forklift level and at a height suitable to fit below the skid.
NOTICE
Risk of unit damage if improperly stored. Keep the unit upright, indoors and protected from
dampness, freezing temperatures and contact damage.
Figure 11 Equipment recommended for handling a Liebert condenser
!
WARNING
Risk of top-heavy unit falling over. Can cause equipment damage, injury or death.
Read all of the following instructions before attempting to move, lift, remove packaging from
or preparing unit for installation.
!
WARNING
Risk of sharp edges, splinters and exposed fasteners. Can cause personal injury.
Only properly trained and qualified personnel wearing appropriate safety headgear, gloves,
shoes, glasses and protective clothing should attempt to move, lift, remove packaging from or
prepare unit for installation.
R