Liebert Air Cooled - Manual (Page 19)

Inspection and Installation
15
3.4 Preparing a 1-, 2-, 3- or 4-Fan Condenser for Moving and Installation
3.4.1 Removing the Skid and Attaching Slings
1. Install the legs, provided by Liebert, on the condenser with the mounting bolts, also provided by
Liebert. Liebert recommends using a 5/8" socket and ratchet.
2. Place slings or equivalent items through holes in the legs on 1, 2- and 3-fan condensers (see Step
2 and Step 3 in Figure 13). Use eyebolts for attaching a sling or similar equipment to 4-fan
units.
3. Using spreader bars and a crane, or similar lifting equipment, lift the condenser off the skid to
allow safely turning the condenser upright.
4. Lift the condenser and move it to the installation location.
Figure 13 Attaching legs and sling to a 1-, 2-, 3- or 4-fan condenser for moving
Step 1
Step 2
Step 3
Three-fan unit shown for illustration.
Method for 1-fan and 2--fan condensers is the same.
Attach sling to 4-fan condensers with eyebolts.