Liebert Air Cooled - Manual (Page 12)

Site Preparation
8
Figure 6 Typical condenser footprint—dimensions
Figure 7 Piping connection locations for 1-, 2-, 3- and 4-fan VFD Control and Fan Speed Condensers
2”
(50.8mm)
9/16" (14mm)
Typical Diameter
1-3/4”
(44.5mm)
4-1/4”
(108mm)
1-3/4”
(44.5mm)
4-1/4”
(108mm)
1”
(25.4mm)
2”
(50.8mm)
Fasten liquid and hot gas lines
to leg using flat surface clamps
with isolators (field-supplied).
Support field piping separately
to avoid coil damage and loss
of charge.
Leaving
Liquid Line
Entering
Hot Gas Line
Traps to extend above
coil base by a minimum
of 7-1/2" (190mm)
Inverted Traps
(field-supplied)
See
Detail
A-A
DPN000665
Rev. 02
Detail A-A
Metal
clamp
Isolator