Lightwave Communications USB-Wizard - Manual (Page 17)

13
System Access List
To enter the System Access List press <Ctrl> + <A> from the User Name List menu.
The System Access List displays a list of numbers representing the ports so the administrator can change access rights to the
ports for the selected user. The user’s name is displayed at the top of the access list. The mouse is used to change access rights
by clicking on a given number to toggle a port’s status. A user that has access to a port can connect to that port and control the
CPU connected to that port when in Normal Mode.
Function: Keystroke:
Save the changes to the access
list and return to previous mode
Exit the System Access List without
saving and return to previous mode.
Figure 13- System Access List screen
USER ACCESS FUNCTIONS
INTRODUCTION
The OSD menu enables a user to name the CPUs connected to the USB
Wizard and connect to them using that name from a
single keyboard and mouse. The OSD is positioned on the user's monitor, displaying 8 CPU names at a time. The screen can be
used for switching as well as editing the CPUs’ names. Through the OSD menu, the user can operate the
USB Wizard to
have the switch cycle through 2 extended modes of operation: COMMAND and SCAN . Two LEDs on the front panel indicate
when these modes are enabled.
OSD Command Mode
When entering the Command Mode from the keyboard using the <Ctrl> + <`> (accent key), the OSD menu will automatically
appear on the monitor in addition to illuminating the COMMAND indicator LED on the USB KVM switch. This provides a visual
way to control the
USB Wizard.
The list below describes the OSD Command functions available from
the keyboard after entering Command Mode and while the COMMAND
LED is illuminated:
Function: Keystroke:
Select the previous port
Select the next port
Enable/disable Scan Mode
Figure 14- Command Mode screen
Enter Edit Mode
Esc
Enter
S
Ctrl
+
E
Ctrl
+
USER ACCESS FUNCTIONS