Lifetime #7525 - Manual (Page 4)

4
POLE SECTION IDENTIFICATION
Identify the pole sections before beginning assembly. Failure to assemble the
pole sections correctly may result in severe personal injury or property damage
as described on Page One.
ONCE THE POLE SECTIONS HAVE BEEN SEATED, THEY
CANNOT BE SEPARATED.
TP MP BP
Top Pole:
Four holes at the
top of the pole, four
holes in the middle,
two holes near the
bottom and one
small hole at the
bottom.
Middle Pole:
One slot at the top
of the pole and one
small hole at the
bottom. Warning
Sticker.
Bottom Pole:
One slot at the top
of the pole and a
dimpled end at the
bottom.
SAFETY INSTRUCTIONS
Most injuries are caused by misuse and/or not following instructions. Use
caution when using this system.
Owner must ensure that all players know and follow these rules for safe operation of
the system.
To ensure safety, do not attempt to assemble this system without following the
instructions carefully. Check entire box and inside all packing material for parts and/
or additional instruction material. Before beginning assembly, read the instructions
and identify parts using the hardware identifier and parts list in this document.
Proper and complete assembly, use and supervision are essential for proper
orientation and to reduce the risk of accident or injury. A high probability of serious
injury exists if this system is not installed, maintained, and operated properly.
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE AND WILL VOID WARRANTY.
• If using a ladder during assembly, use extreme caution.
• Three capable adults are recommended for this operation.
• Assemble the pole sections properly. Failure to do so could cause the pole
sections to separate during play.
• Before digging, contact utility company to locate underground power cables, gas,
and water lines. Ensure that there are no overhead power lines within 20 ft. (7m)
radius of pole location.
• Minimum operational height is 7’6” (2,23m) to the rim.