Operation, Warning – Lincoln Electric INVERTEC V160-S User Manual
Page 16
B-4
OPERATION
B-4
V160-S
DIP SWITCH FUNCTIONS
T
his section has 8 DIP switch functions of the V160-
S. Read and understand the functions before making
any changes because abnormal operation can occur
with the wrong settings. The machine must be turned
OFF when the DIP Switches are changed.
ELECTRIC SHOCK CAN KILL:
Be sure that all installation, opera-
tion, maintenance and repair proce-
dures are performed only by qualified
individuals. Lincoln Electric is not
responsible for damages caused by
improper installation, improper care or abnormal
operation.
Before opening the machine to make changes to
the DIP Switches it must first be turned OFF and
disconnected from the input source. Do not open
the machine or change the DIP Switches with
power applied to the machine. Only Lincoln
trained service technicians are authorized to per-
form these modifications.
------------------------------------------------------------------------
The DIP switches are numbered from 1 to 8 shown in
Figure B.3. Switch 1 is on the bottom and switch 8 is
on the top. When a switch is pushed to the right (or to
the back of the machine) it is ON; when it is pushed to
the left (or to the front of the machine) it is OFF.
The standard production settings for the V160-S are
shown with in bold letters ON Table B.1. If a switch
setting has bold letters ON, do not make any changes;
abnormal operation could occur.
DIP Switch 1: Machine Type
This controls the output of the V160-S and some
welding waveform functions. It configures the V160-S
to automatically turn ON depending on the position of
the Welding Mode switch. Refer to DIP Switch 6 for
more information.
DIP Switch 2 thru 5 non-functional for the V160-S.
FIGURE B.3
WARNING
DIP
Switch 1
DIP
Switch 8
Front of machine
DIP
V160-S V160-S
Switch
CE
USA
1
ON
ON
2
OFF
OFF
3
OFF
ON
4
ON
OFF
5
OFF
OFF
6
OFF
ON
7
OFF
OFF
8
OFF
OFF
TABLE B.1