Lincoln Electric Power MIG 350MP - Manual (Page 5)

Key Controls
Easy to use controls for high productivity and accurate settings.
A. Continuous WFS/Amps Control – In wire feed welding, adjusts
wire feed speed. In stick or TIG modes, adjusts amperage.
B. Continuous Volts/Trim Control – Adjusts voltage when MIG
welding. Adjusts the arc length (trim) when Pulse-MIG welding.
Professional’s Choice – weld with traditional manual control or take
advantage of the included MSP3 digital panel for high tech weld
features:
1. Weld Mode – Many synergic modes to select from for simple
one-knob control.
2. Preflow – Adjustable timer to initiate gas flow before the arc.
3. Post-Flow – Further protect your weld integrity by automatically
setting the gas to run a few seconds after the trigger is released.
4. Run-In – Adjustable speed at which wire strikes the plate to
enhance starting.
5. Start Procedure – Set start procedure, wire feed speed and volts
for an adjustable starting time.
6. Arc Control – Set arc control to crisp or soft depending on your
preference and application. In pulsed MIG, this control varies
the pulse frequency and background current. In Stick mode, it
adjusts the arc force.
7. Crater Control – Adjusts the ending weld procedure and ramp
down time.
8. Burnback – Adjustable time delay between turning off the arc
and the wire feed to prevent wire sticking to the puddle.
9. Spot Timer – Adjustable arc time for repetitive tack and spot
welds.
Power MIG ® 350MP
www.lincolnelectric.com [5]
A CLOSER LOOK
Python ® -Plus Air-Cooled Push-Pull Guns
Features the same Magnum ® back end as the Magnum ® 300 gun,
eliminating the need for the K2154-1 adapter. Effortless, fast
changes between Magnum
® 300 MIG gun and Python ® -Plus
push-pull gun.
• 15 ft. (4.5 m) Order K2447-1
• 25 ft. (7.6 m) Order K2447-2
• 50 ft. (15.2 m) Order K2447-3
(Note: Standard air-cooled and water-cooled Python ® , CobraMax ™ and
Prince ® XL push-pull guns still require the K2154-1 connection kit.)
A
B
1-9
1
FEATURES, CON’T.
Push-Pull Gun
Best performance for production
aluminum welding - Use larger spools.
Spool Gun
Better feeding with
integrated 2 lb. spools
Push Gun
Good for occasional
aluminum work
3 Ways To Feed Aluminum
Better Best Good
Base Unit Includes:
Push Model (K2403-1): Power MIG ® 350MP, Magnum ® 300 Gun 15 ft. (4.5 m), .035" (0.9 mm)/.045" (1.2 mm) Drive Rolls and Guide for Steel,
Regulator and Hose, Work Clamp and Cable, 230V Input Cord and Plug.
Push-Pull One-Pak ® Model (K2451-2): Includes Power MIG ® 350MP (K2403-1) push model, Python ® -Plus push-pull gun 25 ft. (K2447-2), 3/64
Aluminum Drive Roll Kit (KP1695-3/64A).