Lowrance electronic IFINDER PRO - Manual (Page 74)

66
For connectors and wiring information for another device, consult the
factory; phone numbers are in the back of this manual. To set Com Port
Configuration:
1. Press MENU | MENU |
↓ to
S YSTEM S ETUP
| ENT .
2. Press
↓ to
C OM P ORT
| ENT .
Configure DGPS
This unit will recognize Starlink

, Magnavox

and Lowrance DGPS
receivers.
1. Press MENU | MENU |
↓ to
S YSTEM S ETUP
| ENT .
2. Press
↓ to
C OM P ORT
| ENT |
↓ to
C ONFIGURE DGPS | ENT .
3. Press ENT , then use
↑ ↓ → ← to enter the station frequency, then
press ENT .
4. Press
↓ to
B
IT
R
ATE
| ENT then use
↑ ↓ to select the station bit rate,
then press ENT .
5. A. If you are not using a Starlink DGPS receiver, press
EXIT | EXIT | EXIT | EXIT to return to the previous page.
B. If you are using a Starlink DGPS receiver, press
↓ to
A UTO T UNING
|
ENT . Press EXIT | EXIT | EXIT | EXIT to return to the previous page.
Configure NMEA
You can configure the unit to use specific NMEA sentences.
1. Press MENU | MENU |
↓ to
S
YSTEM
S
ETUP
| ENT .
2. Press
↓ to
C
OM
P
ORT
| ENT |
↓ to
C
ONFIGURE
NMEA | ENT .
3. A menu appears showing the prefixes of the available NMEA sen-
tences. A check mark next to a prefix means the prefix is in use. Use
↑
↓ → ← to select a prefix, then press
ENT to turn off the prefix. (Press
ENT again to check the box and turn a prefix on.)