Lexicon RV-5 - Manual (Page 30)

Setup Lexicon
3-4
MENU TIME OUT NONE, 30, 40, 50, 60 SECONDS
Selects the MENU TIME OUT parameter from the On-Screen Display
(OSD) menu. This parameter identifies the length of time before the
OSD menu times out and can be set from 30 to 60 seconds in
ten-second increments. If NONE is selected, then the OSD will not
turn off automatically.
CAUTION!
The NONE selection should only be used with caution. If
the system includes a plasma display, or other display
types sensitive to image burn-in, and the OSD Menu Time
Out parameter is set to NONE, the OSD menu image can be
burned into the monitor display.
BRIGHTNESS FULL, HALF, OFF
Selects the BRIGHTNESS parameter from the Front Panel Display
menu, which selects the brightness of the 2-line front panel display.
The parameter can be set to FULL, HALF, or OFF. If set to OFF, then
the front panel display is off.
On the remote control, this parameter is controlled by the || (Pause)
button while in the touch screen LEX or TUNER menus.
Note: When the RV-5 is powered off or put into Standby mode, any
changes to the BRIGHTNESS parameter are not saved. So when the RV-5
is powered on or taken out of Standby mode again, the BRIGHTNESS
parameter will be set to FULL.
TIME OUT NONE, 1 TO 10 SECONDS
Selects the TIME OUT parameter from the Front Panel Display menu.
This parameter identifies the length of time before the front panel
2-line display times out. The parameter can be set from 1 to 10
seconds in one-second increments. If NONE is selected, then the
2-line front panel display is always on when the RV-5 is on.
DISPLAY SETUP SETUP ON-SCREEN DISPLAY MENU TIME OUT
DISPLAY SETUP SETUP FRONT PANEL DISPLAY BRIGHTNESS
DISPLAY SETUP SETUP FRONT PANEL DISPLAY TIME OUT