Lexicon RV-5 - Manual (Page 35)

RV-5 Setup
3-9
MANUAL SPEAKER SETUP
Selecting the SETUP menu SPEAKER/EQ SETUP menu MANUAL option opens the MANUAL menu, which is used to manually set the speaker
distances, cross-over points, and output levels.
AUTO SETTINGS OFF, ON
Loads the values from the active preset into the speaker cross-over
points, distances, or output level parameters. The Speakers
(cross-over points), Speaker Distances, and Output Levels menus all
have an Auto Settings parameter. All three are the same parameter,
but each affects the individual sub-menus separately and
independently of each other.
If the Auto Settings parameter is set to ON, the parameters in that
menu cannot be manually changed until the Auto Settings
parameter is set to OFF.
Note: Any manual settings will be lost if the active preset settings are
loaded; if Auto Settings is set to ON in the Speakers, Speaker Distances, or
Output Levels menus, then previous parameter values will be overwritten.
MANUAL
SPEAKERS
SPEAKER DISTANCES
OUTPUT LEVELS SPEAKERS
AUTO SETTINGS: OFF
FRONT L/R: 80Hz
CENTER: 80Hz
SIDE L/R: 80Hz
REAR/Z2 L/R: 80Hz
SUB/LFE LPF: 80Hz
SUBWOOFERS: 1
SUB HPF: 20Hz
SUB MODE: NORMAL SPEAKER DISTANCES 1
AUTO SETTINGS: OFF
UNITS: FEET
FRONT LEFT: 0.0 ft
CENTER: 0.0 ft
FRONT RIGHT: 0.0 ft
SIDE RIGHT: 0.0 ft
REAR RIGHT: 0.0 ft
REAR LEFT: 0.0 ft
SPEAKER DISTANCES 2
SIDE LEFT: 0.0ft
SUBWOOFERS: 0.0 ft
OUTPUT LEVELS 1
AUTO SETTINGS: OFF
INPUT: ALL
TEST TONE: AUTO
FRONT LEFT: 0dB
CENTER: 0dB
FRONT RIGHT: 0dB
SIDE RIGHT: 0dB
REAR RIGHT: 0dB
OUTPUT LEVELS 2
REAR LEFT: 0dB
SIDE LEFT: 0dB
SUBWOOFER1: 0dB
SUBWOOFER2: 0dB
SPEAKER/EQ SETUP SETUP
SETUP SPEAKER/EQ SETUP MANUAL AUTO SETTINGS