Land Pride AFM4214 - Manual (Page 26)

24
Section 3: Adjustments
AFM4214 and AFM4216 All-Flex Grooming Mowers 315-587M 5/29/13
Table of Contents
Optional Hydraulic Transport Locks
Refer to Figure 3-5:
With transport locking cylinder (#6) fully retracted,
transport locks (#1) should be fully seated in tool bar
locking lugs (#2) with slight slack in aircraft cables (#5). If
needed, shorten or lengthen cables (#5) as follows:
1. Fully retract deck lifting cylinders (#7) and transport
lock cylinder (#6).
2. Check slack in all three aircraft cables (#5):
a. They should have slight slack and not be tight.
b. They should not be too slack or cables (#5) will
not be able to pull transport locks (#1) out of tool
bar locking lugs (#2).
3. If needed, adjust aircraft cables (#5) as follows:
a. Loosen cable clamps (#4A & #4B) and pull or let
out aircraft cable (#5) to create slight slack in
cable.
b. Use cable clamp (#4A) closest to the spring to
create a loop about 1 1/4" in diameter. The loop
should be big enough to allow rotation around the
spring but small enough not to come off the
washers.
c. Tighten cable clamp (#4A).
d. Secure excess cable with remaining clamp (#4B)
and then tighten clamp (#4B).
NOTE: Figure 3-5 is shown with mower decks down
for clarity. Mower decks will need to be folded up
and locked in the transport locks to check for
adjustment of transport locks.
Wire Rope Adjustment
Figure 3-5
35473